CXR AJ 2885P Instrukcja Użytkownika Pobierz pdf (Strona 21)

User's Manual V34bis Fax-modem - AJ 2885 P

AJ 2885 P - Page 21

4.1.4. Configuration Select

Holding MODE for more than 10 seconds will initiate a hardware reset.

If the switch is still pressed after some beeps are heard at power-up, the modem will enter

configuration mode.

The front panel LEDs DTR, DSR, CD and LINE indicate which configuration the user can select.

There are listed in the following table:

DTR DSR CD LINE Configuration

0 0 1 1 Factory configuration "0" async dial configuration

(AT&F0)

0 1 0 1 Factory configuration "1" sync 2WLL configuration

originate (AT&F1)

0 1 1 1 Factory configuration "2" sync 2WLL configuration

answer (AT&F2)

1 0 0 1 Factory configuration "3" V25bis HDLC dialer (AT&F3)

1 0 1 1 Factory configuration "4" V25bis BSC dialer (AT&F4)

0 0 1 0 User configuration "0" (AT%M0)

0 1 0 0 User configuration "1" (AT%M1)

0 1 1 0 User configuration "2" (AT%M2)

1 0 0 0 User configuration "3" (AT%M3)

1 0 1 0 User configuration "4" (AT%M4)

Each of the configuration will stay on for 2 seconds while the MODE button is pressed.

Releasing the button will select the new configuration, and this configuration will be loaded after

power up. Immediately after the power up test (after the beeps), the LEDs will indicate which

configuration is loaded for 2 seconds.

4.1.5. Factory configuration detail

The following parameters differ from the factory 0 configuration.

• Factory 1 : E0 Q1 &D0 %D2 &C1 %C1 &R0 @A0 &M1 &L2 *LG0 *M1

• Factory 2 : E0 Q1 &D0 %D2 &C1 %C1 &R0 @A0 &M1 &L2 %O0 *LG0 *M1

• Factory 3 : E0 %D2 &C3 %C3 &R0 @V3 %B1 @A0 &M1 *LG0 *M1

• Factory 4 : E0 %D2 &C3 %C3 &R0 @V4 %B1 @A0 &M1 *LG0 *M1

These configurations may change without notice. Please check on your modem.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 48 49

Brak uwag

CXR AJ 2885P Instrukcja Użytkownika Strona 21